ADJUSTMENT INSTRUCTIONS
Chain Adjustment
Chain Adjustment required if the Chain is too loose.
1.Loosen ACORN NUTS(3/8")(70) on both sides of the fan.
2.Adjust the NYLOCK NUT(M6)(67) on the chain side of bike to remove all slack from the chain.
3.Adjust the NYLOCK NUT(M6)(67) on the side opposite
the chain so that the center of the ACORN NUT(3/8")(70) is the same distance from TENSION BRACKET(23) on both sides of bike.
4.Tighten the ACORN NUTS(3/8")(70) on both sides of the fan.
Fan Adjustment
Fan Adjustment is required if the fan locks up or the resistance of the fan increases after use. To adjust the fan, use the following procedures:
STEP 1: Remove the SCREWS holding the CHAIN GUARDS(33, 34) and WIRE CAGES(31, 32) to the BIKE.
STEP 2: Remove the ACORN NUTS(3/8")(70), EYE BOLTS(22), and NYLOCK NUTS(M6)(67) from the AXLE.
STEP 3: Slide the FAN(17) towards the REAR and slide CHAIN(16) off both the FRONT and REAR
SPROCKETS.
STEP 4: Remove the FAN(17) and WIRE CAGES(31, 32) from the BIKE.
11