14
Brush Guard
Hand Grip | Hand Grip |
|
16 | BACK VIEW | |
|
|
|
•Fit the brush guard onto the front clip.
•Insert two #8 x 3/4" screws into the lower holes in the brush guard and tighten.
15
•Insert two #8 x 2" screws into the upper holes in the brush guard and tighten.
• Fit both hand grips on the ends of the handlebar.
Hint: If it is difficult to slide a hand grip onto the handlebar, moisten the inside of the grip with water.
Drive Buttons
17Connector
•Locate the opening under the drive buttons.
•Reach into the opening and pull the high speed connector out through the opening.
•See page 18 for information on high speed operation.
12 |