Rear Wheel Driver
(Slotted Side Down)
Rear Wheel
(Indented Side Down)
Wheel Cover
(Indented Side Down)
2
•Slide a wheel cover, indented side down, onto the rear axle.
•Locate a rear wheel. Slide the wheel, indented side down, onto the rear axle.
•Slide a rear wheel driver, slotted side down, onto the rear axle. Fit the slots on the rear wheel driver onto the pegs on
the wheel.
Motor Assembly
Rear Axle Assembly
3BOTTOM VIEW
•Position the vehicle upside down.
•Slide the rear axle assembly through the hole in the back end of the vehicle, as shown. Make sure the rear wheel driver fits into the pins in the motor assembly inside the vehicle.
Motor Assembly
Rear Wheel
(Pegged Side First)
Rear Wheel Driver | Wheel Cover |
(Slotted Side Out) | (Indented Side Out) |
4
•Slide a rear wheel driver, slotted side out, onto the rear axle. Make sure the rear wheel driver fits into the pins in the motor assembly inside the vehicle.
•Locate the other rear wheel. Slide the wheel, flat side first, onto the rear axle. Make sure the slots on the rear wheel driver fit onto the pegs on the wheel.
•Slide a wheel cover, indented side out, onto the rear axle.
Wrench
5 | 3/8" |
•Fit a 3/8"
•Completely tighten the hex nuts on both sides of the rear wheel assembly with the wrench.
Hint: An extra wrench has been provided to hold the hex nut on one side of the rear axle while tightening the hex nut on the other side.
9 |