Kawasaki P9723 owner manual Battery Charging, Please call

Page 7

BATTERY CHARGING

ELECTRICAL HAZARD

WARNING

Battery can fall out and injure a child if vehicle tips over. Always use battery retainer.

PREVENT FIRE

-Never modify the electrical system. Alterations could cause a fire resulting in serious injury and could also ruin the electrical system.

-Use of the wrong type battery or charger could cause a fire or explosion resulting in serious injury.

-Use of Power Wheels® components in products other than Power Wheels® vehicles could cause overheating, fire or explosion.

The battery must be handled by adults only. The battery is heavy and contains sulfuric acid (electrolyte). Dropping the battery could result in serious injury.

Never allow children to charge the battery. Battery charging must be done by adults only. A child could be injured by the elec- tricity involved in charging the battery.

Read the safety instructions on the battery.

Examine the battery, charger and their connectors for excessive wear or damage each time you charge the battery. If damage or excessive wear is detected, do not use the charger or the battery until you have replaced the worn or damaged part.

CAUTION

Use the charger in dry locations only.

About Thermal Fuses

Your Power Wheels® 12 volt battery is equipped with a built-in thermal fuse. The thermal fuse is a self-resetting safety device which automatically “trips” and shuts down operation of the vehicle if the vehicle is overloaded or the driving conditions too severe. Once a fuse has "tripped", remove your foot from the pedal and wait approximately 25 seconds before operating the vehicle again. To avoid repeated automatic shut-downs, do not overload the vehicle by exceeding the 65 lb. (29.5 kg) maximum weight capacity or by towing anything behind the vehicle. Avoid severe driving conditions, such as driving up slopes or running into fixed objects, which can cause the wheels to stop spinning while power is still being supplied to the motors and make sure your child stops the vehicle before switching direction.

If a thermal fuse in a battery continually trips under normal driving conditions, please contact your local Power Wheels® Authorized Service Center. For the location of the Authorized Service Center nearest to you, visit us on-line at www.powerwheels.com, or call 1-800-348-0751.

Important Notes

Your new battery must be charged for at least 18 hours before you use it in your vehicle for the first time.

We recommend that you start charging your battery before beginning assembly of your new vehicle.

The battery must be upright while charging.

The charger is not a toy.

Do not short circuit the battery.

You do not need to remove the battery from your vehicle to recharge it.

Before charging the battery, examine the battery case for cracks and other damage which may cause sulfuric acid (electrolyte) to leak during the charging process. If damage is detected, do not charge the battery or use it in your vehicle. Battery acid

is very corrosive and can cause severe damage to surfaces it contacts.

Do not charge the battery on a surface (such as a kitchen counter top) which could be damaged by the acid contained inside the battery. Take precautions to protect the surface on which you charge your battery.

Use only a Power Wheels® 12 volt charger with (input 120 VAC, 60 Hz with an output of 12 VDC, 1200 mA) to charge your Power Wheels® 12 volt battery.

Adults Note: Regularly examine the charger for damage to the cord, plug, housing or other parts that may result in the risk of fire, electric shock or injury. In the event of any damage, do not use the charger until the damage has been properly repaired.

Please call 1-800-348-0751.

If your battery is old and will not accept a charge, do not leave it in the vehicle. Always remove a dead battery from the vehicle.

7

P9723pr-0920

Image 7
Contents With Assembly Instructions For Model P9723 Important Information Table of ContentsElectrical Hazard HandlebarSeat Vehicle Steering Column Cap Plate PartsFront Wheels Rear Wheels Front Clip For your convenience, we included extra fasteners Rear Axle Volt Battery#8 x 2 Screw 16 Hex Nut144 Parts PicturePlease call Battery ChargingPower Indicator Battery Charger Connector AssemblyRear Axle 16 Hex Nut Rear Wheel Motor Assembly Rear Axle AssemblyMotor Assembly Rear Wheel Rear Wheel DriverSteering Column Steering Column ConnectorHubcaps Front AxleBushing Wheel Cover Wrench 16 Hex NutBrush Guard Hand Grip Drive Buttons 17ConnectorSeat DecorationRight Side View Motor Harness Seat Drive Buttons Connector Battery InstallationSeat Battery Retainer Power WheelsCare Battery Care and DisposalTo disconnect the motor harness Safe Driving RulesDrive Vehicle OperationReverse Vehicle Care Problem Possible Cause Solution Problems and SolutionsShort run time Less than Undercharged battery Operation of the drive system by raising the rear wheels off Bumper-to-Bumper Limited Warranty Limited WarrantyBefore first-time use You must charge the battery Hours