Kawasaki P9723 Assembly, Power Indicator Battery Charger Connector, Rear Axle 16 Hex Nut

Page 8

Power

Indicator

B

Battery

A

Charger

Connector

Plug the charger connector into the battery A .

Plug the charger into a standard wall outlet B .

Notes:

-Use the charger only in a wall outlet. Do not plug the AC adaptor into a ceiling outlet.

-If power flow to the wall outlet is controlled by a switch, make sure the switch is “ON”.

-The power indicator on the charger does not indicate the charge status of your battery. The power indicator allows you to see that there is power from the wall outlet.

Before first-time use, charge the battery for at least 18 hours. Never charge the battery longer than 30 hours.

Recharge the battery for at least 14 hours after each use of your vehicle. Do not charge the battery longer than 30 hours.

Once the battery is charged, disconnect the charger connector from the battery. Unplug the charger from the wall outlet. The battery is now ready to be installed in your vehicle. Please see the Battery Installation section on page 15 for detailed instructions on installing your battery. If your battery is already installed in your vehicle, simply re-connect the motor harness connector to the battery.

ASSEMBLY

WARNING

Children can be harmed by small parts, sharp edges and sharp points in the vehicle's unassembled state, or by electrical items. Care should be taken in unpacking and assembly of the vehicle. Children should not handle parts, including the battery,

or help in assembly of the vehicle.

Rear Axle

3/8" -16 Hex Nut

1

Fit a 3/8" -16 hex nut onto one end of the rear axle. Hand tighten the hex nut to hold in place.

8

P9723pr-0920

Image 8
Contents With Assembly Instructions For Model P9723 Table of Contents Important InformationElectrical Hazard Front Wheels Rear Wheels Front Clip PartsHandlebarSeat Vehicle Steering Column Cap Plate Rear Axle Volt Battery #8 x 2 Screw16 Hex Nut For your convenience, we included extra fastenersParts Picture 144Battery Charging Please callRear Axle 16 Hex Nut AssemblyPower Indicator Battery Charger Connector Motor Assembly Rear Axle Assembly Motor Assembly Rear WheelRear Wheel Driver Rear WheelSteering Column Connector Steering ColumnFront Axle Bushing Wheel CoverWrench 16 Hex Nut HubcapsDrive Buttons 17Connector Brush Guard Hand GripDecoration SeatRight Side View Battery Installation Seat Battery RetainerPower Wheels Motor Harness Seat Drive Buttons ConnectorBattery Care and Disposal CareSafe Driving Rules To disconnect the motor harnessReverse Vehicle OperationDrive Vehicle Care Problems and Solutions Problem Possible Cause SolutionShort run time Less than Undercharged battery Operation of the drive system by raising the rear wheels off Limited Warranty Bumper-to-Bumper Limited WarrantyBefore first-time use You must charge the battery Hours