Cisco Systems Cisco uBR10012 manual Removing the Cable Interface Line Cards and Uplink Cards

Chapter 3 Installing the Cisco uBR10012 Router

Removing the Power Modules, Fan Assembly, and Line Cards

Figure 3-6 Removing the Fan Assembly Module

CISCO
10000	CISCO

103485

Removing the Cable Interface Line Cards and Uplink Cards

Step 1 To remove the cable interface and network uplink line cards, move to the rear of the chassis. Step 2 Unscrew the top and bottom captive screws (Figure 3-7).

Step 3 Simultaneously pivot both ejector levers away from each other to disengage the line card from the backplane (Figure 3-8).

Step 4 Slide the line card out of the slot (see Figure 3-8).

Step 5 Place the card on an antistatic surface or in an antistatic bag.

Step 6 Repeat Step 2 through Step 5 to remove the other cable interface line cards and the network uplink cards.

Caution If you are using the Cisco uBR-MC28C or Cisco uBR-MC16xx line cards, do not attempt to separate or remove the line cards from the Cisco uBR10-LCP2 adapter card while they are installed in the Cisco uBR10012 chassis. The line cards and adapter cards must be removed from the chassis as a complete unit before they can be separated.

	Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
3-10	OL-18259-01