Cisco Systems Cisco uBR10012 manual Removing the AC Power Entry Module, Power Miswire Fault

Chapter 3 Installing the Cisco uBR10012 Router

Removing the Power Modules, Fan Assembly, and Line Cards

Figure 3-3 Removing a DC PEM

S S L L O O T T 0 1

CISCO
10000	CISCO
	10000
CO
NS

OC

LOE

		NS
		OL
A		E
UX
		A
		UX
A
CT
IVIT		A
ET	Y	CT
HE		IVI
L RN		E TY
INK ET		TH
	S	E
	L SL	LIN RN
	OT OT	K ET
	0 1

POWER
MISWIRE
FAULT	POWER
	MISWIRE
	FAULT

ALARMS

ACO

CRITICAL MAJOR

MINOR

STATUS

FAIL

PERFORMANCE ROUTING ENGINE

ALARMS

ACO

CRITICAL MAJOR

MINOR

STATUS

FAIL

PERFORMANCE ROUTING ENGINE

56463

Removing the AC Power Entry Module

	Use this procedure to remove the AC power entry modules (PEMs) from the Cisco uBR10012 chassis.
Step 1	Remove the front cover on the chassis by lifting it up slightly and then pulling it toward you. See
	Figure 3-1.
Step 2	Verify that the power switch on the AC PEM is turned off. See Figure 3-4.
Step 3	Unplug the AC-input power cord from the power plug on the front panel of the AC PEM.
Step 4	Remove the AC-input power cord from the chassis cord clips and set it aside.
Step 5	Use the screwdriver to loosen the captive screws on the AC PEM you are removing.
Step 6	Pull the AC PEM from the chassis by using the handle on the faceplate. See Figure 3-5.
	Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
OL-18259-01		3-7