Cisco Systems Cisco uBR10012 manual Installing the Cable Management Brackets Optional

Chapter 3 Installing the Cisco uBR10012 Router

Installing the Cable Management Brackets (Optional)

Installing the Cable Management Brackets (Optional)

The Cisco uBR10012 router is shipped with two cable-management brackets that are installed on the rear of the router’s chassis to route the cables connected to the cable interface line cards.

Figure 3-17shows the rear of the Cisco uBR10012 chassis with the two cable-management brackets installed.

Figure 3-17 Installing the Optional Cable Management Brackets

72314

Use the following procedure to install the optional cable-management brackets on the rear of the Cisco uBR10012 chassis:

Step 1 Position the first mounting bracket immediately above the cable interface line card installation slots. Make sure that the portion of the bracket with the slots is above the mounting holes, so that the bracket will not interfere with the insertion and removal of the line cards. See Figure 3-17.)

	Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
OL-18259-01		3-21