Cisco Systems Cisco uBR10012 manual Removing and Replacing a Network Line Card

Chapter 5 Maintaining the Cisco uBR10012 Router

Removing and Replacing a Network Line Card

Removing and Replacing a Network Line Card

Use the following procedure to install a new network line card, or to remove or replace an existing network line card in the Cisco uBR10012 chassis. The following cards are supported:

•Cisco OC-12/STS12c/STM4 POS (UBR10-OC12/P-SMI=)

•Cisco uBR10-SRP-OC12SML-DPT WAN (UBR10-SRP-OC12SML=)

•Cisco Single Port Gigabit Ethernet line card (UBR10-1GE=)

•Cisco uBR10012 OC-48 DPT/POS interface module

Tip To prevent alarms from activating, you can administratively shut down a line card before hot-swapping it. Otherwise, inform the network administrator that this portion of the network will be temporarily interrupted.

Removing the Network Line Card

Warning Class 1 laser product. Statement 1008

Warning Invisible laser radiation present. Statement 1016

Warning Because invisible radiation may be emitted from the aperture of the port when no fiber cable is connected, avoid exposure to radiation and do not stare into open apertures. Statement 1056

Warning Statement for Sweden

Warning Osynlig laserstrålning när denna del är öppen och förregleringen är urkopplad. Rikta inte blicken in mot strålen. Statement 1036

Warning Statement for Finland

Warning Alleviates ja suojalukitus ohitettaessa olet alttiina näkymättömälle lasersäteilylle. Äjä katso säteeseen. Statement 1035

Step 1 Attach an antistatic wrist strap to your wrist and to a bare metal surface on the chassis or frame.

Step 2 Face the back of the Cisco uBR10012 chassis. Clear aside enough interface and power cables to allow sufficient space to work.

	Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
OL-18259-01		5-39