Cisco Systems Cisco uBR10012 manual Installing a DC PEM

Chapter 5 Maintaining the Cisco uBR10012 Router

Removing and Replacing DC Power Entry Modules

Figure 5-14 Installing a DC PEM

CISCO
10000	CISCO
	10000
CO
NS

OC

LOE

				NS
				OL
	A			E
	UX
				A
				UX
	A
	CT
	IVI			AC
	E	TY
	TH			TIV
S	ER			IT
L SL	LIN NE			ET Y
OT OT	K	T	S	HE
0 1			L SL	LIN RN
			OT OT	K ET
			0 1

POWER
MISWIRE	POWER
FAULT
	MISWIRE
	FAULT

ALARMS

ACO

CRITICAL MAJOR

MINOR

STATUS

FAIL

PERFORMANCE ROUTING ENGINE

ALARMS

ACO

CRITICAL MAJOR

MINOR

STATUS

FAIL

PERFORMANCE ROUTING ENGINE

56464

Step 11 Turn on the DC power sources that are providing power for the DC PEMs. The FAULT LED on each replacement DC PEM lights (yellow) to indicate that the DC PEM is receiving power from the power source but is not yet supplying power to the Cisco uBR10012 chassis.

Step 12 Push up the power switch on each replacement DC PEM to the on () position (see Figure 5-10). When you turn on the power switch on each DC PEM, its FAULT LED turns off and the POWER LED lights (green).

Step 13 Replace the front cover (see the “Replacing the Front Cover” section on page 5-4).

	Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
OL-18259-01		5-17