Cisco Systems Cisco uBR10012 manual Cisco uBR10-LCP2-MC28C Cable Interface Line Card

Chapter 5 Maintaining the Cisco uBR10012 Router

Removing and Replacing the Cable Interface Line Card in the Adapter Card

Figure 5-58 Cisco uBR10-LCP2-MC28C Cable Interface Line Card

	LCP2 connector
	MC28C
	connector
Ejector tab Guide	L-Bracket
	Backplane
Ejector	connector

ENABLED
US0
	US1
	US2
	US3
Captive screw	US4
	US5

US6

US7

Handle

uBR- MC28C DS0

DS1

L-Bracket

nut and washer

Guide

58720

Captive screw

Ejector tab

Ejector

Step 3 Loosen and remove the two sets of retaining nuts and washers on the L-brackets on the Cisco MCxx board (see Figure 5-58). Set the nuts and washers aside.

Step 4 Loosen and disengage the two captive screws on the Cisco MCxx board (see Figure 5-58).

Step 5 Use the ejector levers on each side of the Cisco uBR10-LCP2 adapter card to loosen and disengage the Cisco MCxx card from the adapter card (see Figure 5-59).

Step 6 Using the handle, pull the Cisco MC28C card straight out of the Cisco uBR10-LCP2 adapter card (see Figure 5-60).

Step 7 Place the Cisco MCxx card aside, on an antistatic surface.

	Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
5-66	OL-18259-01