Cisco Systems Cisco uBR10012 manual Removing the Cable Interface Line Card from the Adapter Card

Chapter 5 Maintaining the Cisco uBR10012 Router

Removing and Replacing the Cable Interface Line Card in the Adapter Card

Step 6 Connect all downstream and upstream coaxial cables to the cable interface line card as necessary.

Step 7 Configure the cable interface line card if necessary (refer to the Cisco uBR10012 Router Software Configuration Guide for information about configuring the line card).

Note It is not necessary to configure the cable interface line card if you are installing a replacement card in the identical slot. The system automatically downloads the necessary configuration information from the PRE.

Removing and Replacing the Cable Interface Line Card in the Adapter Card

The following section describes how to remove and replace a Cisco MCxx cable interface line card in the Cisco uBR10-LCP2 adapter card.

Note This procedure pertains to all Cisco MCxx cable interface line cards (Cisco MC16x and Cisco MC28C) used with the Cisco uBR10-LCP2 adapter card.

Tip Make sure you are using an ESD-preventive wrist strap, and have an appropriate antistatic surface work space, as detailed in the “Preventing Electrostatic Discharge Damage” section on page 2-2.

Removing the Cable Interface Line Card from the Adapter Card

Step 1 Remove the Cisco uBR10-LCP2-MCxx cable line card, as described in steps 1 through 6 in the “Removing and Replacing a Cable Interface Line Card” section on page 5-60.

Caution Do not attempt to separate or remove the Cisco MCxx card from the Cisco uBR10-LCP2 adapter card while the two cards are installed in the Cisco uBR10012 chassis. The cards must be removed from the chassis as a unit and then separated on a lab bench or other area that protects against ESD damage.

Step 2 Place the cable line interface card on an anti-static surface. The component side should be facing up, as shown in Figure 5-58.

Note This illustration uses the Cisco MC28C cable interface card as an example. You can perform this procedure using any of the Cisco MCxx cards.

	Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
OL-18259-01		5-65