Cisco Systems Cisco uBR10012 manual Installing the AC PEM

Chapter 5 Maintaining the Cisco uBR10012 Router

Removing and Replacing AC PEM Modules

Figure 5-20 Installing the AC PEM

CISCO
10000	CISCO
	10000
CO
NS

OC

LOE

				NS
				OL
	A			E
	UX
				A
				UX
	A
	CT
	IVI			AC
	E	TY
	TH			TIV
S	ER			IT
L SL	LIN NE			ET Y
OT OT	K	T	S	HE
0 1			L SL	LIN RN
			OT OT	K ET
			0 1

POWER
FAULT	POWER
	FAULT

ALARMS

ACO

CRITICAL MAJO R MINOR

STATUS

FAIL

PERFORMANCE ROUTING ENGINE

ALARMS

ACO

CRITICAL MAJOR

MINOR

STATUS

FAIL

PERFORMANCE ROUTING ENGINE

62524

Step 6 Position the replacement AC PEM in the power bay and push it forward, verifying that it goes all the way in and makes a secure connection with the backplane.

Step 7 Use the screwdriver to tighten the captive screws to secure the unit to the chassis.

Step 8 Plug the AC-input power cable into the power receptacle on the front panel of the AC PEM.

Step 9 Route the power cable up the front of the AC PEM and clip it into the two plastic retaining clips attached to the surface of the PEM. Route the power cable out through the right side, so that it will fit through the notch on the right side of the front bezel cover. (see Figure 5-21).

	Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
5-24	OL-18259-01