Cisco Systems Cisco uBR10012 manual Removing the DC Power Entry Modules, Turning Off a DC PEM

Chapter 3 Installing the Cisco uBR10012 Router

Removing the Power Modules, Fan Assembly, and Line Cards

Removing the DC Power Entry Modules

Use this procedure to remove the DC power entry modules (PEMs) from the Cisco uBR10012 chassis.

Step 1 Verify that the first DC PEM you are removing is turned off by pushing the three-levered power switch down to the OFF (0) position (Figure 3-2).

Step 2 Loosen the captive screws on the DC PEM.

Step 3 Pull the PEM straight out from the chassis, using the two handles on the faceplate (Figure 3-3). Step 4 Set the DC PEM aside.

Step 5 Repeat Step 1 through Step 4 to remove the second DC PEM, and set it aside as well.

Figure 3-2 Turning Off a DC PEM

ALARMS

ACO

CRITICAL MAJOR

MINOR

STATUS

FAIL

PERFORMANCE ROUTING ENGINE

ALARMS

ACO

CRITICAL MAJOR

MINOR

STATUS

FAIL

PERFORMANCE ROUTING ENGINE

OFF OFF OFF

56461

Cisco uBR10012 Universal Broadband Router Hardware Installation Guide

3-6 OL-18259-01