Cisco Systems Cisco uBR10012 manual LCD Module, Fan Assembly Cable

Chapter 1 Cisco uBR10012 Universal Broadband Router Overview

Cisco uBR10012 Universal Broadband Router Modules

Caution Although the fan assembly supports hot-swapping and can be replaced without interruption to system operation, to prevent overheating, do not operate the system without the fan assembly for more than a few minutes.

Fan Assembly Cable

The fan assembly cable connects the fan assembly to the backplane. The cable is located inside the chassis, underneath the fan assembly. Ordinarily the cable is not removed when a fan assembly module is removed from the chassis.

Note The cable has different connectors on each end. See Figure 1-7

Figure 1-7 Fan Cable

Male connector

62338

Female connector

LCD Module

The LCD module provides real-time operating status and configuration information for the chassis and line cards. The buttons below the screen provide a menu system that allows you to display different parts of the system configuration without using a terminal. Figure 1-8shows the Cisco LCD module without the chassis front cover.

Figure 1-8 LCD Module Display Panel

62391

Keypads

Note The LCD module functions depend on the release of the Cisco IOS software running on your Cisco uBR10012 router. Refer to the release notes for the Cisco IOS release you are using, and the Cisco uBR10012 Software Configuration Guide, for details. See the “Obtaining Documentation and Submitting a Service Request” section on page xxi.

	Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
1-14	OL-18259-01