Cisco Systems Cisco uBR10012 manual Inserting an SFP Module, Inserting the SFP Module

Chapter 5 Maintaining the Cisco uBR10012 Router

Removing and Replacing an SFP Module

Step 3 Unlock and remove the SFP module as follows:

a.Mylar Tab SFP Modules—Gently, but firmly pull the plastic tab to free the locking pin and remove the SFP module (Figure 5-52).

Caution Do not twist the Mylar tab when you remove the SFP module. Twisting the tab may disconnect it from the module.

b.Bale Clasp Modules—Open the bale clasp to release the locking pin and remove the SFP module (Figure 5-52).

Step 4 Insert a dust plug into the optical ports of the removed SFP module to keep the optical interfaces clean, and place the module in an antistatic bag or other protective environment.

Inserting an SFP Module

Use the following procedure to insert an SFP module into the HHGE line card.

Step 1 Attach an antistatic wrist strap to your wrist and to an ESD socket on the chassis, or to a bare metal surface on the chassis or frame.

Figure 5-53 Inserting the SFP Module

CISCO 10000

FAIL

LINK

0

TX RX

Dust plug

GIGABIT ETHERNET

76419

Step 2 Gently insert the SFP module into the line card port until the edge connector is fully seated in the connector. You will hear a click as the triangular pin on the bottom of the SFP module snaps into place (Figure 5-53).

	Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
5-58	OL-18259-01