Cisco Systems Cisco uBR10012 manual Console Port Connection on the PRE Module

Chapter 3 Installing the Cisco uBR10012 Router

Connecting the Console Port and Auxiliary Port

Figure 3-39 Console Port Connection on the PRE Module

CISCO 10000

CONSOLE

AUX

SLOT SLO

T 0 1

LINK
E
THE
LINK	RNET

30027

Step 2 Run the other end of the crossover cable through the square hole at the left front side of the chassis, and connect it to the RJ-45-to-DB-9 adapter (see Figure 3-40):

Figure 3-40 Connecting an RJ-45-to-DB-9 Console Cable Adapter

30028

Step 3 Connect the adapter to the appropriate serial port on the PC or terminal to complete the console port cable connection.

Step 4 Power on the PC or terminal.

Step 5 Configure the PC terminal emulation software or the terminal for the following default settings:

•9600 baud

•8 data bits

•No parity generation or checking

•1 stop bit

•No flow control

Step 6 If also connecting a modem to the auxiliary port, go to the next section, “Connecting to the Auxiliary Port.” Otherwise, go to the “Connecting Network Management Cables” section on page 3-52to continue the installation.

	Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
3-50	OL-18259-01