IBM SC30-3681-08 Initial-control-timeout, Valid Values Default Value Example, Lecs-atm-address

Con®guring Forum LE Clients

Default Value:

If the ELAN type is token ring, the default is 4544. If the ELAN type is Ethernet, the default is 1516.

Example:

LEC Config> set frame-size 4544

initial-control-timeout

This parameter sets the value of the initial control timeout used in the control timeout algorithm described in 302.

Valid Values:

1 - 10

Default Value:

5

Example:

LEC Config> set initial-control-timeout 10

lecs-atm-address

Speci®es the ATM address of the LECS.

If the client is set to auto con®gure, it attempts to connect to a LECS. If it is unable to connect to a LECS, then it may try another LECS ATM address. The LECS ATM addresses that are tried, in order, are:

1.This con®gured LECS address

2.Any LECS address obtained through ILMI

3.The well-known LECS address de®ned by the ATM Forum.

No default is provided.

Note: This command should be entered on one command line. It is shown here on two lines because of spacing.

Example:

LEC Config> set lecs-atm-address 39.84.0F.00.00.00.00.00.00.00.00.00.01.10.00.5A.00.DE.AD.01

les-atm-address

Sets the LES ATM address. This command may be optional or required depending upon the setting of lecs-auto-con®g as described in theset auto-con®gcommand on page 300.

vIf auto-con®g is YES, the les-atm-address is not con®gurable.

vIf auto-con®g is NO, then the les-atm-address is required.

Specify the ATM address of the LES. No default is provided.

Note: This command should be entered on one command line. It is shown here on two lines because of spacing.

Example:

LEC Config> set les-atm-address 39.84.0F.00.00.00.00.00.00.00.00.00.01.10.00.5A.00.DE.AD.02

mac-address

Sets the MAC address for this LE client. You may specify that the client use the burned-in MAC address of the ATM interface, or you may specify a

304MRS V3.2 Software User's Guide