ISDN Con®guration Commands

 

remove

Add

Adds a caller's number to be blocked.

List

Lists the callers' numbers to be blocked.

Remove

 

Removes a caller's number for the list to be blocked.

Disable

The disable command disables Power Source 1 detection. If your switch does not supply Power Source 1, you should disable PS1.

Note: This command is valid only for BRI.

Syntax:

 

disable

ps1

Note: On the U interface ISDN BRIs, there is no ps1 detect circuitry and the value of this ®eld is ignored.

Enable

The enable command enables Power Source 1 detection. If your ISDN switch supplies Power Source 1 (PS1), you should enable PS1 on the interface. This causes the interface to detect when the switch shuts down and to clear all information about the last call before it reestablishes the connection. For Euro-NET3 switches supporting restricted power mode, PS1 must be enabled.

Do not enable PS1 if your switch does not supply Power Source 1.

Note: This command is valid only for BRI.

Syntax:

 

enable

ps1

Note: On the U interface ISDN BRIs, there is no ps1 detect circuitry and the value of this ®eld is ignored.

List

The list command displays the current ISDN con®guration.

Syntax: list Example: list

 

ISDN Configuration

Local Network Address Name

= line-1-local

Local Network Address

= 1-508-555-1234

Local Network Subaddress

= 21

Maximum frame size in bytes

= 2048

Outbound call address Timeout

= 180 Retries = 2

Switch-Variant-Model

= US National ISDN-1

Multipoint Selection

= Point-to-Point

628MRS V3.2 Software User's Guide

Page 664
Image 664
IBM SC30-3681-08 manual Isdn Conguration Commands, Syntax Disable Ps1, Syntax Enable Ps1