IBM SC30-3681-08 manual Connector-Type, IP-Encapsulation, Physical-Address

Ethernet Con®guration Commands (Talk 6)

Table 33. Ethernet Con®guration Command Summary (continued)

Command	Function
Physical-Address	Sets the physical MAC address.
Exit	Returns you to the previous command level. See ªExiting
	a Lower Level Environmentº on page 11.

Connector-Type

Use the connector-typecommand to set the connector type. 2210s support AUI (10BASE5) and RJ-45 (10BASE-T) connectors, and auto-con®g options.

Syntax:

connector-typename

IP-Encapsulation

Use the IP-encapsulationcommand to select Ethernet (Ethernet type X'0800') or IEEE 802.3 (Ethernet 802.3 with SNAP). Enter e or i.

Syntax:

ip-encapsulationtype

List

Use the list command to display the current con®guration for the Ethernet interface including the connector-type, IPX encapsulation type, and IP encapsulation type.

Syntax:
list	all
Example:
list all
Connector type:	AUI (10BASE5)
MAC Address:	12:15:00:FA:00:FE

Physical-Address

Use the physical-addresscommand to set the physical (MAC) address.

physical-address

This command lets you indicate whether you want to de®ne a locally administered address for the Ethernet interface's MAC sublayer address, or use the default burned-in address (indicated by all zeros). The MAC sublayer address is the address that the Ethernet interface uses to receive and transmit frames.

Note: Pressing Enter leaves the value the same. Entering 0 causes the router to use the burned-in address. The default is to use the burned-in address.

Valid Values: Any 12-digit hexadecimal address.

Default Value: burned-in address (indicated by all zeros).

252MRS V3.2 Software User's Guide