IBM SC30-3681-08 manual Dna

Using the CONFIG (Talk 6) Process

You can change the con®guration parameters of the following protocols and features, but you cannot activate the changes using the reset command:

vAppleTalk

vVines

vOSI/DECnet V

vLNM

vXTP

vWAN Restoral

vWAN Reroute

You must restart the device to activate these con®guration changes.

There are also requirements for certain functions. They are:

PPP dial	A PPP dial circuit cannot be reset if any of the dial circuit parameters have
circuits	changed.
Frame Relay	A Frame Relay dial circuit cannot be reset if any of the dial circuit
dial circuits	parameters have changed.
Compression	Compression requires large header and trailer sizes. Unless compression is
	already enabled on some other interface, it is likely that the header and
	trailer sizes will be too small. In this case, compression is disabled
	automatically on the interface and an ELS message is logged (rather than
	causing the entire reset interface to fail).
Bridging	v Bridging was not already active.
	v NetBIOS ®lters are de®ned on the interface you are resetting.
	v The reset interface caused a change to the bridge personality or behavior
	(for example, adding SR port to pure TB bridge or SR-TB conversion
	enabled).
BGP	Use the BGP reset neighbor command to activate neighbor con®guration
	changes.
APPN	Use the activate_new_con®g command to activate con®guration changes.
IPX	Use the IPX reset command to activate con®guration changes for static
	routes, static services, and ®lter-lists.
DNA IV	Use the DNA IV set command to activate con®guration changes.
SNMP	Use the SNMP revert command to activate con®guration changes.

Chapter 5. The Con®guration Process (CONFIG - Talk 6) and Commands 49