ATM Interface Con®guration Commands (Talk 6)

Example:

ATM INTERFACE> set max-mp-parties 300

trace Sets the packet tracing parameters on the interface. Packet tracing can be enabled or disabled on a range of VPI/VCI values. Common VPI/VCI values to trace are:

v0/5 for signalling packets

v0/16 for ILMI packets.

Valid Values:

ON or OFF

Default Value:

ON

You are prompted for the VPI/VCI range you want to trace.

Beginning VPI Valid Values:

0 ± 255

Default Value:

0

Ending VPI Valid Values:

0 - 255

Default Value:

255

Beginning VCI Valid Values:

0 - 65535

Default Value:

0

Ending VCI Valid Values:

0 - 65535

Default Value:

65535

Example:

ATM INTERFACE> set trace on beginning of VPI range [0]? 0 end of VPI range [255]? 0 beginning of VCI range [0]? 5 end of VCI range [65535]? 5

uni-version

Sets the User Network Interface (UNI) version used by the ATM interface with communicating with the attached ATM switch. If the UNI versions are con®gured on the ATM switch and ATM device interface to a speci®c version (not AUTO-DETECT), the UNI versions must match.

If the UNI version is con®gured as AUTO, the ATM device attempts to learn the UNI version to use from the switch.

In UNI AUTO-DETECT mode, if the switch does not respond to the query for UNI version, the default is UNI 3.0. If the switch responds with a value other than UNI 3.0 or UNI 3.1, the default is UNI 3.1.

Valid Values:

[UNI 3.0UNI 3.1AUTO-DETECTNone]

Chapter 22. Con®guring and Monitoring ATM 283

Page 319
Image 319
IBM SC30-3681-08 manual On or OFF, You are prompted for the VPI/VCI range you want to trace, 65535, Uni-version