IBM SC30-3681-08 manual Enter password again, Enter permission, V25-bis-address, V34-address

CONFIG Commands

When the ®rst user is added, console login is automatically enabled. Each user added must be assigned one of the permission levels de®ned in Table 5.

When users are added, set login authentication to local. Otherwise a remote server must be used.

Table 5. Access Permission

Permission Level	Description
Administrator (A)	Displays con®guration and user information,
	adds/modi®es/deletes con®guration and user information.
	The Administrator can access any router function.
Operator (O)	Views router con®guration, views statistics, runs potentially
	disruptive tests, dynamically changes router operation, and
	restarts the router. Operators cannot modify the permanent
	router con®guration. All actions can be undone with a
	system restart.
Monitor (M)	Views router con®guration and statistics but cannot modify
	or disrupt the operation of the router.
Tech Support	Allows your service representative to gain access to the
	router if a password is forgotten. Cannot be assigned to
	users.

Note: To add a user, you must have administrative permission. You do not have to reinitialize the router after adding a user.

Example:

add user John Enter password: Enter password again:

Enter permission (A)dmin, (O)perations, (M)onitor [A]?

Do you want to add Technical Support access? (Yes or [No]):

Enter password

Speci®es the access password for the user. Limited to 80 alphanumeric characters and is case-sensitive.

Enter password again

Con®rms the access password for the user.

Enter permission

Speci®es the permission level for the user: A, O, or M (see Table 5).

Do you want to add Technical Support access?

This is only an option if the user has a Dial In Access load. See

Table 5.

v25-bis-address

Adds the local and remote numbers of the V.25bis end-points that communicate with the router. The network address-namecan be anything, such as a description of the port. You can use any string of up to 23 printable ASCII characters. The network-dial-addressis the telephone number of the local or destination port. For more information, see ªChapter 41. Using the V.25bis Network Interfaceº on page 579.

Note: You can use punctuation, such as parentheses and dashes, but the punctuation is not signi®cant (the router uses only the numbers).

Example: add v25-bis-address remote-site baltimore 1-909-555-0983

v34-address

Adds the local and remote numbers of the V34 end-points that will be

58MRS V3.2 Software User's Guide