Point to Point MAC/data-link on SCC Serial Line interface
Adapter cable: V.35 DCE RISC Microcode Revision:
0
V.24 circuit: 105 106 107 108 109
Nicknames: RTS CTS DSR DTR DCD
PUB 41450: CA CB CC CD CF
State: ON ON ON ON ON
Line speed: unknown
Last port reset: 1 minute, 54 seconds ago
Input frame errors:
CRC error 0 alignment (byte length)
0
missed frame 0 too long (> 2182 bytes)
0
aborted frame 0 DMA/FIFO overrun
0
Output frame counters:
DMA/FIFO underrun errors 0 Output aborts sent
0
Net Interface number as assigned by software during initial configuration.
Net’ Base interface number as assigned by software during initial configuration.
Note: For dial circuit interfaces, Net’ is different from Net. For dial circuit
interfaces, Net’ indicates the base interface (ISDN or V.25bis)that
the dial circuit uses.
Interface No
Type of interface and its instance number.The Point-to-Point interface type
is PPP.
CSR Command and status register addresses of the base network.
Vec Interrupt vector address.
Self-Test: Passed
Totalnumber of times the point-to-point interface passed its self-test.
Self-Test: Failed
Totalnumber of times the point-to-point interface failed its self-test.
Maintenance: Failed
Totalnumber of maintenance failures.
Adapter cable
Type of adapter cable that has been configured; for example, V.35DTE.
V.24circuit
Circuits being used on the V.24.Note: The symbol---inmonitoringoutput
indicates that the value or state is unknown.
Nicknames
Control signals Note: The symbol---inmonitoring output indicates that the
value or state is unknown.
PUB 41450
Pin assignments Note: The symbol---inmonitoring output indicates that
the value or state is unknown.
State State of the V.24circuits (on or off). Note: The symbol---inmonitoring
output indicates that the value or state is unknown.
Monitoring PPP Interfaces (Talk 5)
Chapter33. Configuring and Monitoring Point-to-Point Protocol Interfaces 507
||
||
|
|
|