IBM SC30-3681-08 manual Remote-dte, Add local command, Refer to Software Users Guide

XTP Con®guring Commands (Talk 6)

Example:

add peer-router

Router©s internal IP Address [0.0.0.0]?128.185.100.2

Connection setup timeout [230]?

remote-dte

Adds remote X.25 nodes and corresponding routers. You can connect remote nodes with local X.25 nodes so they can exchange data. You must con®gure an IP address for each remote X.25 node you con®gure. Any request or data sent to this remote node goes to the router. The router then uses one of its local X.25 interfaces to forward the data to the X.25 node.

	De®ne a remote DTE if this router is to initiate XTP connections to the
	remote DTE due to incoming calls from its local DTEs, or if the remote DTE
	is part of an XTP PVC de®nition.
	To use Local XTP, the peer router address must be the internal address of
	the local router and that DTE address must be previously de®ned using the
	add local command.
	Example:
	add remote-dte
	DTE address [ ]?301
	Peer router©s internal IP Address [0.0.0.0]?128.185.100.2
	Peer router©s internal IP Address [0.0.0.0]?
pvc	Adds a PVC from a local X.25 node to a remote X.25 node.
	Three things need to exist in order to activate a PVC con®guration:
	v An X.25 PVC from the router to the local X.25 node
	v An X.25 PVC from the peer router to the remote X.25 node
	v A TCP connection to the peer router where the remote node is resident
	Example:
	XTP config>add pvc
	Local PVC Range Start [1]?
	Local PVC Range End [1]?
	Local X.25 DTE address [ ]? 101
	Remote PVC Range Start [1]?
	Remote PVC Range End [1]?
	Remote X.25 DTE address [ ]? 301
	Notes:
	1. When you add PVCs to the router con®guration, you also must
	con®gure the PVC in X.25. For details on con®guring X.25 interfaces,
	refer to Software User's Guide
	2. For Local XTP, you must de®ne the PVC in both directions. You need
	this de®nition because the router is performing both local and remote
	functions. For example, to de®ne Local PVC 8 and Remote PVC 10
	when you are using Local XTP, you would do the following:
	XTP config>add pvc
	Local PVC Range Start [1]? 8
	Local PVC Range End [1]? 8
	Local X.25 DTE address [ ]? 108
	Remote PVC Range Start [1]? 10
	Remote PVC Range End [1]? 10
	Remote X.25 DTE address [ ]? 301
	XTP config>add pvc
	Local PVC Range Start [1]? 10
	Local PVC Range End [1]? 10
	Local X.25 DTE address [ ]? 310
	Remote PVC Range Start [1]? 8
	Remote PVC Range End [1]? 8

Chapter 29. Con®guring and Monitoring XTP 377