IBM SC30-3681-08 manual List isr, List hprcp

Monitoring PPP Interfaces (Talk 5)

list isr
APPN ISR Statistic	In	Out
-------------	--	---
Packets:	220	219
Octets:	1266	1157
Prot Rejects:	0	-

hprcp Lists statistics for APPN HPR Control Protocol packets. These ®elds are the same as those described under the list ip command. (Seeªipº on page 503

.)

Example:

list hprcp
APPN HPRCP Statistic	In	Out
---------------	--	---
Packets:	3	3
Octets:	12	12
Prot Rejects:	0	-

hpr Lists statistics on the APPN HPR packets received and transmitted over the

PPPinterface. These ®elds are the same as those described under thelist ip command. (See ªipº on page 503.)

Example:

list hpr
APPN HPR Statistic	In	Out
-------------	--	---
Packets:	780	715
Octets:	131907	69685
Prot Rejects:	0	-

LLC

Use the LLC command to access the LLC monitoring prompt. LLC commands are entered at this new prompt. See ªLLC Monitoring Commandsº on page 239 for an explanation of each of these commands.

Note: This command is available only when APPN is included in the software load.

Syntax:

llc

Point-to-Point Protocol Interfaces and the GWCON Interface Command

The PPP interface traffic is carried by an underlying data-link level device driver. Additional statistics that can be useful when monitoring PPP links may be obtained from the device driver statistics which are displayed using the interface command from the GWCON environment. (For more information on the interface command, refer to ªChapter 10. The Operating/Monitoring Process (GWCON - Talk 5) and Commandsº on page 127.)

The statistics in this section are displayed when you run the interface command from the GWCON environment (talk 5) for the following interfaces used in point-to-point con®gurations:

Example:

+int 1			Self-Test	Self-Test Maintenance
Net	Net©	Interface	Passed	Failed	Failed
1	1	PPP/0	2	0
0

506MRS V3.2 Software User's Guide