IBM SC30-3681-08 manual Circuit Configset selftest-delay

Using V.25bis

Circuit Config>set calls outbound

Circuit Config>set calls inbound

Note: For WAN Restoral operations or another dial-on-demand application, you should set up the circuit for either inbound or outbound calls.

5.Specify the timeout period for the circuit.

Use the set idle command. If there is no traffic over the circuit for this speci®ed time period, the dial circuit hangs up. To con®gure the circuit as a dedicated circuit, set the idle timer to zero. To con®gure the circuit to dial on demand, set the idle timer to a value other than zero. The range is 0 to 65535 and the default is 60 seconds. For example:

Circuit Config>set idle

Idle timer (seconds, 0 means always active) [60]? 0

Note: For WAN Restoral or WAN Reroute operations you must set the idle time to 0.

6.Optionally, you can delay the time between when a call is established and the initial packet is sent.

Use the set selftest-delaycommand. Setting a selftest delay can prevent initial packets from being dropped. If your modems take extra time to synchronize, adjust this delay. For example:

Circuit Config>set selftest-delay

Selftest delay(milli-seconds,0 means no delay)[150]?200

7.Set the inbound address name.

Use the set inbound command. You need to use this command only if you set up the circuit for both inbound and outbound calls and if the router's destination address is different from the destination address that the remote router dials. For example, the numbers would be different if one of the routers must go through a PBX, international, or inter-LATA exchange. For example:

Circuit Config>set inbound

Assign destination inbound address name []? newyork

The inbound address name must match one of the names that you de®ned using the add v25-bis-addresscommand.

8.Set the duplexing mode for the circuit using the set duplex command.

9.Set the encoding mode for the circuit using the set encoding command.

10.Optionally, you can enter the con®guration process for the data-link layer protocol that is running on the dial circuit (PPP or Frame Relay). Use the encapsulator command. For example:

Circuit Config>encapsulator

582MRS V3.2 Software User's Guide