IBM SC30-3681-08 manual Cir-defaults, Default Value 64

Con®guring Frame Relay Interfaces

For the status of the network to be considered network up, the number of events in error within the window must be less than n2 prior to any change in status.

Syntax:
set	cable*
	cir-defaults
	clocking*
	encoding*
	frame-size
	idle . . .	*
	ir-adjustment . . .
	line-speed*
	lmi-type n1-parameter
	n2-parameter
	n3-parameter
	p1-parameter
	t1-parameter
	transmit-delay . . .		*
	ty-parameter

*Note: The commands with an * following them are not available for FR dial circuit interfaces.

cable physical-interface-link-type data-connection-type Sets the cable type for the network physical link.

A DTE cable is used when you are attaching the router to some type of DCE device (for example, a modem or a DSU/CSU). A DCE cable is used when the router is acting as the DCE and providing the clocking for direct attachment.

The available options are:

Physical Interface Link Type	Data Connection Type
EIA 232 (RS-232)	DTE, DCE
V35	DTE, DCE
V36	DTE
X21	DTE, DCE

cir-defaults

Sets the default values for the circuit congestion parameters. The parameters are:

cir Sets the default value of cir to the value provided by a Frame Relay network provider.

Valid Values: 0 or 300 to 204 800 bps

Default Value: 64 000

bc Sets the default value of bc to the value provided by a Frame Relay network provider.

428MRS V3.2 Software User's Guide