remote-dte
pvc
cug Specifies the closed user group numbers for the XTP protocol. The first
CUG you are prompted for is the preferred cug.
Valid values: 0 to 9999
Default value: None
Example:
add cug
Pref CUG []? 114
CUG (2) []? 314
CUG (3) []? 478
CUG (4) []?
bi-cug Specifies the bilateral closed user group numbers for the XTP protocol. The
first bi-cug you are prompted for is the preferred bi-cug.
Valid values: 0 to 9999
Default value: None
Example:
add bi-cug
Pref BI-CUG []? 50
BI-CUG (2) []? 51
BI-CUG (3) []? 52
BI-CUG (4) []? 53
BI-CUG (5) []? 54
local-dte
Adds the X.25 DTE addresses, or the X.25 nodes, that communicate with
the router on the specified interface. The valid interface numbers for use
with XTP are 0 to 255.
Youcan configure multiple local nodes. However, if the option to allow
incoming calls without a calling DTE address has been selected and such a
call is received, the

last

local DTE address added becomes the calling DTE
address for that call.
Example:
add local-dte
Interface number [0]?4
Allow inbound calls without calling DTE address? (Y or N) [N]? y
DTE address [ ]?101
Pref CUG []? 23
CUG (2) []? 24
CUG (3) []? 25
CUG (4) []? 26
CUG (5) []? 27
Pref BI-CUG []? 6
BI-CUG (2) []? 7
BI-CUG (3) []? 8
BI-CUG (4) []? 9
BI-CUG (5) []? 10
DTE address [ ]?
peer-router
Adds peer routers. Enter the internal IP addresses of the routers to which
the remote X.25 nodes are connected. Youcan use these IP addresses to
open TCP connections and transport X.25 packets that contain connection
requests and X.25 data.
If the internal IP address you configure for the peer-router is this router’s
internal IP address, the software establishes a local XTP connection.
XTP Configuring Commands (Talk6)
376 MRS V3.2 Software User’s Guide
|
|
|
|