Syntax:
retrieve
Save
Use the save command to store the current configuration (except counters). Save
does not affect the default configuration (the one you set with the configuration
commands). Use save after modifying the configuration with the monitoring
commands with the intention of saving this configuration over a restart. There can
be only one saved configuration at a time. Toreload the saved configuration, use
the retrieve command.
Syntax:
save
Set
Use the set command to set the maximum number of traps per second, to set the
timestamp feature, or to set the tracing options.
Syntax:
set pin...
remote-logging...
timestamp...
trace...
pin Use the set pin command to set the pin parameter to the maximum
number of traps that can be sent on a per-second basis. Internally, the pin
resets every tenth of a second. (One tenth of the number
max_traps
is sent
every tenth of a second.)
remote-logging
Use the set remote-logging command to configure remote logging options.
When these options are configured from the monitoring environment, the
changes take effect immediately,and return to their previously configured
settings when the device is rebooted.
Syntax:
set remote-logging on
off
facility...
level...
local_id
remote_ip_addr...
source_ip_addr ...
on Turns remote logging on. Remote logging is now enabled to allow
any messages selected by the remote command to be actively
logged.
ELS Monitoring Commands (Talk5)
198 MRS V3.2 Software User’s Guide