IBM SC30-3681-08 Add bandwidth %, Drop bandwidth %, Bandwidth test interval sec, Max frag size

Con®guring MP
	Add bandwidth %
	The amount of bandwidth utilization at which the software will try to
	add a new link.
	Valid Values: 1 to 99
	Default Value: 90
	Drop bandwidth %
	The amount of bandwidth utilization at which the software will
	remove a link from the MP bundle.
	Valid values: 1 to 99
	Default value: 70
	Bandwidth test interval (sec)
	The time, in seconds, after which the software will check the
	bandwidth utilization to determine whether to add or drop a link
	from the bundle.
	Valid Values: 10 to 200 seconds
	Default Value: 15
calls Speci®es whether this MP interface will initiate outbound calls, only accept
	outbound calls, or participate in both types of calls.
	Valid values: inbound, outbound, or both
	Default value: inbound
	Note: If you specify outbound or both, the software will request the net
	number of the dedicated MP link that will place the ®rst call.
	Example:
	set calls outbound
	Dialout MP link net for this MP net []? 4
idle	Speci®es the time period in seconds that an interface can have no protocol
	traffic at which the MP interface will end calls on all the links.

Valid Values: 0 to 65535

Default Value: 0

mp parameters

Prompts you to enter the maximum and minimum fragment sizes and the maximum number of active links.

Example:

set mp parameters
Max frag		size [750]?	675
Min	frag	size [375]?	300
Max	number of active		links [2]? 4

Max frag size

Speci®es the largest of number of bytes of data a packet can contain before the packet is fragmented to be sent over MP links.

Valid Values: 100 to 3 000

Default Value: 750

518MRS V3.2 Software User's Guide