IBM SC30-3681-08 manual Add another Dial Circuit Yes, No Yes No

Interface #:	13
Interface Type:	PPP Dial Circuit
Base Intferface #:	6	(ISDN Base Net)
Idle timer:	0	(fixed circuit)
Call Direction:	Inbound only
Destination Name:	default_address
Line ID *IN* Name:	* ANY *

Is this correct (Yes, No): [Yes] Yes

4.Next, you may choose to add/edit more dial-circuits in the same way as the example above.

Add another Dial Circuit (Yes, No): [Yes] No

5.Finally, you will be asked to con®rm the dial-circuit con®guration and exit the dial-circuit con®guration section. Answering y will save the dial-circuit con®guration and answering n will discard changes made during this con®guration session.

Current Dial Circuit Configuration:
Num Intf# Intf Type		BaseIntf# MP		Direction
Destination
1 13	PPP Dial Circuit	6/ISDN	No	In

default_addre

Save this configuration (Yes, No): [Yes] Yes

Dial circuit configuration saved.

Con®guring Dial-in Access to LANs (DIALs) Interfaces and DIALs Server Information

If the router you are con®guring contains the DIALs feature, then you will be asked if you want to con®gure DIALs interfaces and DIALs server information. You will only be asked to con®gure DIALs interfaces if you have con®gured V34 on a base WAN interface or if an ISDN interface exists in your router. The following prompts lead you through the DIALs con®guration:

**********************************************************

Dial-in Access to LANs (DIALs) Configuration

**********************************************************

Type ©Yes© to Configure DIALs Configuration

Type ©No© to skip DIALs Configuration Configuration

Type ©Quit© to exit Quick Config

Configure DIALs Interfaces? (Yes, No, Quit): [Yes]

1.Take one of the following actions:

v Enter y to display the DIALs Interface prompts

vEnter n to skip DIALs Interface con®guration

vEnter q to exit quick con®guration

If you answer yes and there ISDN is loaded on this device, the following question will be shown.

658MRS V3.2 Software User's Guide