IBM SC30-3681-08 manual Default value none, Net-Route Mask, Hostname, Time-Allotted, Callback type

CONFIG Commands

A user pro®le-based IP address to offer to a dial-in client if

requested. There are a number of ways for a 2210 to obtain an IP

address for a dial-in client. See ªIP Control Protocolº on page 462

for more information.

Valid values: any valid IP address

Default value: none

Net-Route Mask

Mask for a network user.

If the dial-in user is connecting to a DIALs-enabled PPP interface,

the router automatically adds a temporary static route to that client

for the duration of the PPP session. Typically, this static route has a

net mask of 255.255.255.255 (the default value), which implies that

there is a single IP host at the other end of the PPP link. However,

the net mask can be overridden. If con®gured, this mask is used

when adding the temporary route. An example of this is a small

router with a single network of hosts that dials into a DIALs-enabled

router. The single route to the small office router will be installed

automatically based on the user pro®le, making it unnecessary to

con®gure routing protocols between the two hosts and cutting down

on routing traffic overhead over a potentially slow link.

Hostname

Hostname to be sent to the Proxy DHCP server for use by Dynamic

DNS. See ªUsing a Dial-In Access to LANs (DIALs) Serverº in

Using and Con®guring Featuresfor more information.

Time-Allotted

The length of time a DIALs user can be connected. This is the total

for this session, and should not be confused with an inactivity timer.

Valid Values: 0 to 71 827 788 minutes (0=unlimited)

Default Value: 0

Callback type

Call-back method, either ªRoamingº or ªRequired.º The call-back

parameters are used to specify whether the router will call back the

user and what number to call back. See ªCon®guring PPP Callbackº

on page 459 for additional information.

Dial-Out

Enables dial-out.

This parameter is speci®c to clients using the DIALs dial-out client.

Enabling dial-out for a ppp-user allows this user to access a

modem-pool of dial-out circuits. See ªUsing a Dial-In Access to

LANs (DIALs) Serverº in Using and Con®guring Featuresfor more

information.

Set encryption key

Speci®es whether ECP encryption is to be enabled for this

user/port.

Valid values: yes, no

Default value: no

ECP encryption key

Enter 16-character ECP encryption key.

Chapter 6. Con®guring and Monitoring the CONFIG Process 55