IBM SC30-3681-08 manual Enter current password, Enter new password again, Pppuser

CONFIG Commands

Example:

change password

Enter current password:

Enter new password:

Enter new password again:

Enter current password

Speci®es your current password.

Enter new password

Speci®es your new password.

Enter new password again

Speci®es your new password again for con®rmation. If your con®rmation does not match the previous new password, the old password remains in effect.

ppp_user

Changes the information for a speci®c PPP user.

Syntax:
change ppp_user	encryption-key
	parameters
	password

encryption-key

Changes the encryption key for a PPP user. The following example shows the dialog for changing an encryption key.

Example - Change Encryption key:

Config>change ppp_user encryption-key

Enter user name: []? leslie

Enable encryption for this user/port (y/n) [No]:y

Encryption key should be 16 characters long.

Encryption Key (16 characters ) in Hex(0-9, a-f, A-F):

Encryption Key again (16 characters) in Hex(0-9, a-f, A-F):

User ©leslie© has been updated

Config>

parameters

Changes all of the ppp-user options for a user. This parameter works similar to the add ppp_user except that the values shown within the [ ] are the current values and the change command does not verify the changes or list them back to you when you are done. See ªAddº on page 52 for details about theadd ppp_user command.

password

Changes the password for the PPP user.

Example - Change password:

Config>change ppp_user password

Enter user name: []? sam

Password:

Enter password again:

User ©sam© has been updated

Config>

user Modi®es the user information that was previously con®gured with theadd user command.

Note: To change a user, you must have administrative permission.

Example:

60MRS V3.2 Software User's Guide