IBM SC30-3681-08 manual Conguring Dial-Circuits

Current Multilink PPP Configuration:
Num	Intf#	Direction	Max Links	Link Intf#	Base Intf#	Destination
1	7	In	3	8	6	default_ad

Save this configuration (Yes, No): [Yes] y

Multilink PPP configuration saved.

Con®guring Dial-Circuits

The following con®guration questions are displayed for dial-circuit con®guration:

**********************************************************

Dial Circuit Configuration (w/o DIALs)

**********************************************************

Type ©Yes© to Configure Dial Circuits

Type ©No© to skip Dial Circuits Configuration

Type ©Quit© to exit Quick Config

Configure Dial Circuits? (Yes, No, Quit): [Yes] y

1.Take one of the following actions:

v Enter y to display the Dial-Circuit con®guration prompts

vEnter n to skip Dial-Circuit con®guration and continue quick con®guration

vEnter q to exit quick con®guration

The following status message appears upon entering the dial-circuit con®guration. Note that in this example there is no existing dial- circuit con®guration:

Current Dial Circuit Configuration:
Num Intf# Intf Type	BaseIntf# MP Direction ...
Destination
1 New Circuit

Choose the circuit you wish to edit/add: (1 - 1): [1] 1

2.Choose to add a new dial-circuit by selecting the number at the bottom of the

list denoted by ²New Circuit². Choose to edit an existing dial-circuit con®guration by selecting the number of the dial-circuit which you wish to edit (Note: in the above example, there are no existing dial-circuits). The following is an example of the prompts that will be displayed to add a new, PPP, inbound dial-circuit:

Enter interface # of Base Net, "?" for List,"Q" to quit: (6)

Enter type of dial circuit for this net: (PPP, FRAME-RELAY): [FRAME-RELAY] PPP

Set Call Direction (Inbound, Outbound, Both): [Both] Inbound

Accept ANY INBOUND call (Yes, No): [No] Yes

3.After answering all of the questions, you will be given a con®rmation for the dial-circuit as shown below:

Appendix A. Quick Con®guration Reference 657