IBM SC30-3681-08 manual Dialout MP link net, Max fragment size, Min fragment size, BAP enabled

		Con®guring MP
Dialout MP link net
		The dial circuit con®gured to place the ®rst call for an outbound MP circuit.
Max fragment size
		Speci®es the largest number of bytes of data a packet can contain before
		the packet is fragmented to be sent over MP links.
Min fragment size
		This is the minimum size of the fragments (in bytes) the software creates
		when a packet exceeds Max fragment size.
Maximum number of active links
		Speci®es the con®gured maximum number of links in the MP virtual link
		(also known as bundle).
Links associated with this MP bundle
		Displays the links dedicated to this MP interface.
BAP enabled
		Speci®es whether BAP is enabled on this interface.
Add bandwidth percentage
		The amount of bandwidth utilization at which the software will try to add a
		new link if BAP is enabled.
Drop bandwidth percentage
		The amount of bandwidth utilization at which the software will remove a link
		from the MP bundle if BAP is enabled.
Bandwidth test interval
		The time, in seconds, after which the software will check the bandwidth
		utilization to determine whether to add or drop a link from the bundle.
Set
Use the set command to con®gure:
v The MP interface for inbound or outbound calls
v	The idle timeout
v	The MP parameters
v	The BAP parameters
Syntax:
set		bod parameters
		calls
		idle
		mp parameters
bod parameters
		Prompts you to specify the BOD add and drop bandwidth percentages and
		the BOD test interval.
		Example:
		set bod parameters
		Add bandwidth % [90]? 80
		Drop bandwidth % [70]? 50
		Bandwidth test interval (sec) [15]? 25

Chapter 35. Con®guring and Monitoring Multilink PPP Protocol (MP) 517