IBM SC30-3681-08 manual Node Number, Node address, Circuit Number or name, Pvc-group groupname

Con®guring Frame Relay Interfaces

Node Number

De®nes the node number of the interface attached to the remote

AppleTalk host.

Node address

De®nes the DECnet node address of the remote DECnet host.

Con®gure the node address in the formatx.y, where x is a 6-bit

area address and y is a 10-bit node number.

Circuit Number or name

De®nes the PVC by DLCI or name or SVC by name that this

remote protocol address is associated with.

pvc-group groupname

Adds a required PVC group name.

Note: SVCs may not belong to a required PVC group.

switched-virtual-circuit

Adds a switched virtual circuit (SVC). The SVC will act similar to a PVC

except that the SVC's bandwidth will be allocated for it dynamically by the

FR network only when the SVC is active. The number of SVCs that can be

added is similar to the number of PVCs that can be added in that the

number depends on the throughput required for each circuit, the line speed,

etc. However, since the bandwidth for an SVC is only reserved when the

SVC is active, it may be possible to support more SVCs over an interface

than PVCs.

FR 4 Config>add switched-virtual-circuit

Circuit name []? svc01

Remote party number []? 12345

Remote party number numbering plan (E.164 or X.121) [E.164]?

Remote party number type (Unknown or International) [International]?

Remote party subaddress in hexadecimal []? 01

Remote party subaddress format (private or NSAP) [private]ı?

Requested outgoing Committed Information Rate (CIR) in bps [64000]?

Minimum acceptable outgoing Committed Information Rate (CIR) in bps [64000]?

Requested incoming Committed Information Rate (CIR) in bps [64000]?

Minimum acceptable incoming Committed Information Rate (CIR) in bps [64000]?

Requested outgoing Committed Burst size (Bc) in bits [64000]?

Requested incoming Committed Burst size (Bc) in bits [64000]?

Requested outgoing Excess Burst size (Be) in bits [0]?

Requested incoming Excess Burst size (Be) in bits [0]?

Idle timer in seconds [60]?

Establish circuit to learn remote protocol addresses [Y]?

Is multicast required for this circuit [Y]?

Are call-ins allowed for this circuit [Y]?

Circuit name

Speci®es the circuit name for the SVC. This name will be used to

associate the call with both a protocol and a BRS de®nition and will

be used to identify a connection instead of a circuit number.

Valid Values: A 1 - 32 character ASCII string

Default Value: The name is required and must be unique for this

interface

Remote party number

Speci®es the remote destination's Frame Relay address.

Valid Values: A 1 - 20 character string of decimal digits

Default Value: None

Chapter 31. Con®guring and Monitoring Frame Relay Interfaces 409