list Displays the current packet tracing options on the ATMinterface.
Example:
ATM Interface+ trace
on | off | list []? list
Packet trace is ON
Range of VPIs to be traced: 0 - 0
Range of VCIs to be traced: 32 - 39
on Starts packet tracing on all active VCCs within the specified VPI/VCI range.
Example:
ATM Interface+ trace on
beginning of VPI range [0]?
end of VPI range [0]?
beginning of VCI range [32]?
end of VCI range [65535]? 39
off Stops packet tracing on all VCCs.
Example:
ATM Interface+ trace off
ATM Interface+ trace list
Packet trace is OFF
Wrap
Use the wrap command to perform a loopback data test on the ATMinterface of
the adapter. Wrap can be issued on a per VC basis by specifying VPI-VCI pairs.
Data is looped back internally.
Youcan selectively start a wrap, stop a wrap, or display the current wrap settings.
If you stop or display a wrap, the following statistics will be displayed:
vWrap transmits
vWrap receives
vWrap transmit errors
vWrap receive errors
vWrap receive timeouts
For display, the current wrap statistics are displayed.
For stop, the final wrap statistics are displayed.
Syntax:
wrap display
start
stop
displayDisplays the current wrap settings.
start Starts the wrap procedure and specifies the VPI-VCI length of pattern and
the pattern itself.
Example:
ATM Interface+ wrap start
VPI [0]?
VCI [32]?
wrap pattern length [32]?
Enter 32-byte wrap pattern: [ABCDEFGHIJKLMNOPQRSTUVWXYZ123456]?

ATM Interface Monitoring Commands (Talk5)

Chapter22. Configuring and Monitoring ATM 289