IBM SC30-3681-08 RIF-Timer for Token-Ring Forum-compliant LEC only, Remove, Syntax Rif-timer

	Con®guring Forum LE Clients
Syntax:
set	max-reserved-bandwidth
	traffic-type
	peak-cell-rate
	sustained-cell-rate
	qos-class
	max-burst-size

Example:

ARP entry ©identifier© config> set ?

MAX-RESERVED-BANDWIDTH

TRAFFIC-TYPE

PEAK-CELL-RATE

SUSTAINED-CELL-RATE

QOS-CLASS

MAX-BURST-SIZE

See Con®guring and Monitoring Quality of Service (QoS) inUsing and Con®guring Features for detailed information about the QoS parameters.

List

Use the list command to display information about ARP con®guration.

Remove

Use the remove command to remove an con®gured MAC address or Route

Descriptor LE-ARP entry.

Select the ARP entry number to be removed from the list provided.

Syntax:

removearp-entry-number

RIF-Timer (for Token-Ring Forum-compliant LEC only)

Use the RIF-Timercommand to set the maximum amount of time that information in the RIF is maintained before it is refreshed. Range is 0 to 4096. The default is 120 seconds.

Syntax:

rif-timer value

Example:

rif-timer 100

Source-Routing (for Token-Ring Forum-Compliant LEC only)

Use the source-routingcommand to enable or disable end station source-routing. Source routing is the process by which end stations determine the source route to use to cross source routing bridges. Source routing allows the IP, IPX, and AppleTalk Phase 2 protocols to reach nodes on the other side of the source route bridge.

Chapter 24. Con®guring and Monitoring LAN Emulation Clients 297