IBM SC30-3681-08 manual Htf-address, Adds a Defense Data Network DDN X.25 address translation

Con®guring the X.25 Network Interface

Note: You will not be prompted for this value if you have not enabled the bilateral closed user group facility using the national enable command.

htf-address

Adds a Defense Data Network (DDN) X.25 address translation.

Example:

add htf-address Protocol [IP] Convert HTF address

Protocol

Speci®es the protocol that you are running over the X.25 interface. DDN supports IP only.

Convert HTF address

Converts the protocol address to a destination X.121 address in Host Table Format (HTF) format. Also see ddn-address-translations in the Enable/Disable commands section.

protocol

Enables a protocol encapsulation and de®nes the associated parameters.

Example:

add protocol Protocol [IP]? Window Size [2]?

Default Packet Size [128]? Maximum Packet Size [256]? Circuit Idle Time [30]?

Max VCs [4]?
Pref CUG	[]? 1
CUG (2)	[]? 2
CUG (3)	[]? 3
CUG (4)	[]? 4
CUG (5)	[]? 5
Pref BI-CUG		]? 11
BI-CUG (2)		[]? 12
BI-CUG (3)		[]? 13
BI-CUG (4)		[]? 14
BI-CUG (5)		[]? 15

QLLC example:

X.25 Config> add prot

Protocol [IP]? dls

Idle timer [30]?

QLLC response timer (in decaseconds) [2]?

QLLC response count [3]?

Accept Reverse Charges [N]?

Request Reverse Charges [N]?

Station Type (1) PRI (2) SEC (3) (PEER) [3]?

Max Packet Size [128]?

Packet window size [7]?

Max Message Size [1500]?

Call User Data (in hex, 0 for null) []?

Pref CUG []? 20

CUG (2) []? 21

CUG (3) []?

Pref BI-CUG []?

Protocol

Speci®es which protocol's encapsulation parameters you want to add: APPN, XTP, IP, DECnet, IPX, DLSw, or Banyan VINES. The default is IP.

Window Size

Speci®es the maximum negotiable packet window size, the number

Chapter 27. Con®guring and Monitoring the X.25 Network Interface 345