IBM SC30-3681-08 manual Conguring an ATM Forum-Compliant LE Client, ARP Conguration

Con®guring Forum LE Clients

Con®guring an ATM Forum-Compliant LE Client

This section explains the commands for con®guring an ATM Forum-compliant LAN Emulation Client. Enter the appropriate commands at either the Ethernet Forum Compliant LEC Config> prompt or the Token Ring Forum Compliant LEC Config>

prompt. Commands in the following table apply to both Token-Ring and Ethernet LECs except where indicated.

Enter the commands at the LEC Config> prompt after entering the con®g command at the LE Client Config> prompt.

Table 42. LAN Emulation Client Con®guration Commands Summary

Command	Function
? (Help)	Displays all the commands available for this command level or
	lists the options for speci®c commands (if available). See
	ªGetting Helpº on page 10.
ARP-Con®guration	Allows you to con®gure the LE-ARP con®guration for the ATM
	Forum-compliant client
RIF-Timer	Sets the maximum amount of time that information in the RIF
	is maintained before it is refreshed. Applies only to Token-Ring
	LECs.
Source-routing	Used to enable or disable source-route bridging. Applies only
	to Token-Ring LECs.
IP-Encapsulation	Sets the IP encapsulation as Ethernet (type X'0800') or IEEE
	(802.3 with SNAP). Applies only to Ethernet LECs.
List	Lists the LAN Emulation Client con®guration.
QoS-Con®guration	Gets you to theelan-x LEC QoS Config> prompt from which
	you can con®gure Quality of Service as described in LE Client
	QoS Con®guration Commands inUsing and Con®guring
	Features.
Set	Sets the LAN Emulation Client parameters.
Exit	Returns you to the previous command level. See ªExiting a
	Lower Level Environmentº on page 11.

ARP Con®guration

Use the arp-con®gurationcommand to con®gure the static LE-ARP entries for the ATM forum-compliant LAN Emulation Client.

Syntax:

arp-con®guration

Example:

Token Ring Forum Compliant LEC Config> arp-configuration

ATM LAN Emulation Clients ARP configuration

Table 43. ATM LAN Emulation Client ARP Con®guration Commands Summary

Command	Function
? (Help)	Displays all the commands available for this command level or
	lists the options for speci®c commands (if available). See
	ªGetting Helpº on page 10.
Add	Adds an LE-ARP cache entry using a MAC or route descriptor
	ARP.
Con®g	Sets cache entry QoS parameter values.
List	Lists con®gured ARP cache entries.

Chapter 24. Con®guring and Monitoring LAN Emulation Clients 295