IBM SC30-3681-08 manual Isdn Monitoring Commands, Syntax Channels

ISDN Monitoring Commands
	remove
Add	Adds a caller's number to be blocked.
List	Lists the callers' numbers to be blocked.
Remove
	Removes a caller's number for the list to be blocked.

Calls

Use the calls command to list the number of completed and attempted connections made for each dial circuit mapped to this interface since the last time statistics were reset on the router.

Syntax: calls

Example:

calls
Net	Interface	Site	Name	In	Out	Rfsd	Blckd
4	PPP/1	v403		2	0	0	0
Unmapped connection			indications:	0

Net Number of the dial circuit mapped to this interface.

Interface

Type of interface and its instance number.

Site Name

Network address name of the dial circuit.

In Inbound connections accepted for this dial circuit.

Out Completed connections initiated by this dial circuit.

Rfsd Connections initiated by this dial circuit that were refused by the network or the remote destination port.

Blckd Connection attempts that the router blocked. The router blocks connection attempts if all available channels are in use, if the maximum retries are used up and the router is waiting for the timer to count down, or if layer 1 is up, but layer 2 is down.

Unmapped connection indications:

Connection attempts that were refused by the router because there were no enabled dial circuits that were con®gured to accept the incoming calls.

Channels

The channels command lists the statistics for a channel on the ISDN Primary Rate Interface.

Syntax:

channels

636MRS V3.2 Software User's Guide