Con®guring Frame Relay Interfaces

Establish circuit to learn remote protocol addresses

Speci®es whether this SVC should be established when the

interface comes up to learn the protocol addresses of the adjacent

node. This option can be used in place of statically con®gured

destination protocol names and addresses for protocols that support

dynamic address discovery, such as IP, IPX, Appletalk2, and

DECnet IV to force the router to learn the protocol addresses

associated with the remote device via directed InARP. Using this

option may help reduce ARP broadcasts. The idle timer will be used

to disconnect the SVC once the protocol addresses are learned.

Valid Values: yes or no

Default Value: yes

Is multicast required for this circuit

Speci®es whether or not this SVC should be used to transmit

multicast packets on this interface even if it means setting the SVC

up just to do so. You may use static routes to keep from requiring

multicast over SVCs so that the SVCs will not be established just to

exchange routing information.

Valid Values: yes or no

Default Value: Defaults according to the multicast emulation setting

at the interface level

Are call-ins allowed

Speci®es whether or not a call-in from this remote DTE should be

accepted. Specifying no can be used to block call-ins from speci®c

users and help eliminate call-in/call-out race conditions.

Valid Values: yes or no

Default Value: yes

Compression capable

Speci®es whether Frame Relay compression is supported

Valid Values: yes or no

Default Value: yes, if compression is enabled for the interface.

Otherwise, no.

Encryption capable

Speci®es whether encryption is supported for this SVC.

Valid Values: yes or no

Default Value: yes, if encryption is enabled for the interface.

Otherwise, no.

Change

Use the change permanent-virtual-circuitcommand to change any previous

PVCs that were added with the add permanent-virtual-circuitcommand.

Syntax:

 

change

permanent-virtual-circuit . . .

switched-virtual-circuit . . .

412MRS V3.2 Software User's Guide

Page 448
Image 448
IBM SC30-3681-08 manual Establish circuit to learn remote protocol addresses, Valid Values yes or no, Default Value yes