Set
Use the set command to configure local X.25 node addresses, maximum number of
calls, frame and packet level window size, lowest to highest PVC and SVC
channels, and the idle time for a switched circuit.
Syntax:
set address...
cable
calls-out...
clocking...
default-window-size...
encoding
equipment-type...
htfaddr...
inter-frame-delay...
mtu
national-personality...
pvc...
speed...
svc
throughput-class...
vc-idle...
address
x.25-node-addr
Sets the local X.25 interface address (
x.25-node-addr
). Set the X.25 node
address to 0, not to 00, to delete the local X.25 address.
Example: set address 8982800
cable
type
Sets the cable type as follows:
vRS-232 DTE
vRS-232 DCE
vV35 DTE
vV35 DCE
vV36 DTE
vX21 DTE
vX21 DCE
A DTE cable is used when you are attaching the router to some type of
DCE device (for example, a modem or a DSU/CSU).
A DCE cable is used when the router is acting as the DCE and providing
the clocking for direct attachment.
calls-out
value
Sets the maximum number of locally initiated, simultaneously active SVCs.
Configuring the X.25 Network Interface
328 MRS V3.2 Software User’s Guide
|
|
|
|
|
|
|
|