Using XTP

4.Enter set clocking followed by internal or external based on your router type.

X.25 Config>set clocking internal

5. Enter set speed followed by the access rate (line speed).

X.25 Config>set speed

Access rate in bps [9600]?19200

6.Enter set equipment-typeand specify whether the frame and packet levels act as DCE or DTE.

X.25 Config>set equipment-type dce

7. Enter set pvc and de®ne the lowest and the highest PVC you are using.

X.25 Config>set pvc low 1

X.25 Config>set pvc high 1

8. Enter add pvc to de®ne individual PVCs.

X.25 Config>add pvc

Protocol [IP]?xtp

Packet Channel [1]?

Destination X.25 Address [ ]?101

Window Size [2]?

Packet Size [128]

9.(Optional) Enter national enable truncate-called-addresses. If you want to truncate the called address size, enter national set truncate-called-addr- size followed by the number of digits to truncate the called DTE address to.

10.(Optional) Enable CUG support, CUG insertion, and CUG deletion as required.

Interface 2

Use the following instructions to con®gure interface 2.

1.At the Config> prompt, enter network followed by the number of the X.25 interface. In Figure 20 on page 366, it is 2.

Config>network 2

X.25 User Configuration

X.25 Config>

2.Use the same procedures as de®ned in ªInterface 1º on page 367 to set the following parameters for interface 2:

vaddress = 200

vclocking = internal

vspeed = 19200

vequipment = dce

3.Enter set svc and de®ne the lowest and highest SVC you are using.

There are three types of SVCs: two-way, inbound and outbound. The defaults are ªsvc low-two-way = 1º and ªsvc high-two-way = 64.º All other SVC types default to 0. For additional information on SVCs and PVCs, refer to Software User's Guide

X.25

Config>set svc ?

X.25

Config>set svc low-inbound 0

X.25

Config>set svc high-inbound 0

X.25

Config>set svc low outbound 0

X.25

Config>set svc high outbound 0

X.25

Config>set svc low-two-way 2

X.25

Config>set svc high-two-way 2

4. Exit the X.25 Config> prompt.

X25 Config>exit

Config>

368MRS V3.2 Software User's Guide

Page 404
Image 404
IBM SC30-3681-08 manual Enter set speed followed by the access rate line speed, Enter add pvc to dene individual PVCs