IBM SC30-3681-08 Accessing the Frame Relay Monitoring Prompt, Frame Relay Monitoring Commands

Con®guring Frame Relay Interfaces

line hello packets between the lines. # is between 0 and 15 extra ¯ags. The default is zero (0). Setting this parameter provides 0 to 15 extra ¯ags between transmit frames. Table 59 lists the units and range values for serial interfaces.

Table 59. Transmit Delay Units and Range for the 2210 Serial Interface

Unit	Minimum	Maximum
Extra Flags	0	15

ty-parameter time

Con®gures the interval after which the device considers an existing congestion condition indicated by the receipt of a CLLM message to be cleared. If the device receives a CLLM message before the timer expires, the device resets this timer.

Valid Values: 5 to 30 seconds.

Default Value: 11 seconds.

Accessing the Frame Relay Monitoring Prompt

To access the Frame Relay operating commands and to monitor Frame Relay on your router, perform the following steps:

1.At the OPCON prompt (*), type talk 5.

2.At the GWCON prompt (+), enter the interface command to see a list of interfaces con®gured on the router.

3.Enter the network command followed by the network number of the frame relay interface. For example:

+net 2

Frame Relay Monitoring

FR 2 >

Frame Relay Monitoring Commands

This section summarizes and then explains the Frame Relay Monitoring commands. Use these commands to gather information from the database. Table 60 shows the commands.

Table 60. Frame Relay Monitoring Commands Summary

Command	Function
? (Help)	Displays all the commands available for this command level or lists the
	options for speci®c commands (if available). See ªGetting Helpº on page
	10.
Clear	Clears statistical information on the Frame Relay interface.
Disable	Disables CIR monitoring and congestion monitoring on the Frame Relay
	interface.
Enable	Enables CIR monitoring and congestion monitoring on the Frame Relay
	interface.
List	Displays statistics speci®c to the data-link layer and Frame Relay
	management.
LLC	Displays the LLC monitoring prompt.
Notrace	Disables packet tracing capability for individual circuits or for the entire
	interface.
Set	Sets CIR, Committed Burst Size, and Excess Burst Size for a Frame
	Relay VC.

432MRS V3.2 Software User's Guide