IBM SC30-3681-08 manual Permanent-virtual-circuit pvc#

Con®guring Frame Relay Interfaces

Syntax: llc

Remove

Use the remove command to delete any PVC, Required PVC group, or protocol-address previously added using the add command.

Syntax:

remove	permanent-virtual-circuit . . .
	protocol-address
	pvc-group
	switched-virtual-circuit circuit-name
permanent-virtual-circuit pvc#
	Deletes any con®gured PVC in the range 16 to 1007.
	Notes:
	1. When you delete a PVC that is running compression, the interface
	decreases the count of active compression PVCs. If this action brings
	the count of compression PVCs below the limit, you will receive a
	message to that effect.
	2. When you delete a PVC that is running encryption, the interface
	decreases the count of active encryption PVCs.
	Note: Encryption support is optional. If your software load does not
	include encryption, you will not see encryption-related
	parameters.
protocol-address
	Deletes any con®gured protocol addresses (static ARP entries). This
	parameter prompts you for different information depending on the type of
	protocol that you are adding.
	Example:
	remove protocol-address
	Protocol name or number [IP]?
	IP protocol:
	IP Address [0.0.0.0]?
	Circuit Name or Number [16]?
	IPX protocol:
	Host Number (in hex)[]?
	Circuit Name or Number [16]?
	AppleTalk Phase 2 protocol:
	Network Number (1-65279) []?
	Node Number (1-253) []?
	Circuit Name or Number [16]?
	DN protocol:
	Node address [0.0]?
	Circuit Name or Number [16]?

426MRS V3.2 Software User's Guide