ATM Interface Con®guration Commands (Talk 6)

Default Value:

UNI 3.0

Note: Must be compatible with the ATM switch.

Example:

ATM INTERFACE> set uni-version 3.0

network-id

Sets the network id of the ATM interface. Multiple ATM interfaces should have the same network id if there is ATM connectivity between the interfaces.

Valid Values:

0 - 255

Default Value:

0

Enable

Use the enable command to enable an ESI in the con®guration of your ATM device. The ATM interface attempts to register only enabled ESIs when it activates.

Syntax:

enable

esi esi-address

esi esi-address

Address of End System Identi®ers.

Valid Values:

Any 12 hexadecimal digits

Default Value:

none

Example: enable esi

ATM INTERFACE> enable esi 00:00:00:00:00:09

Disable

Use the disable command to disable an ESI in the con®guration. ATM components using disabled ESIs will not become active on the next router restart.

Syntax: disable

esi esi-address

esi esi-address

Address of End System Identi®ers.

Valid Values:

Any 12 hexadecimal digits

Default Value:

none

Example: disable esi

ATM INTERFACE> disable esi 00:00:00:00:00:09

284MRS V3.2 Software User's Guide

Page 320
Image 320
IBM SC30-3681-08 Uni, Network-id, Valid Values Default Value, Address of End System Identiers, Any 12 hexadecimal digits