Current Multilink PPP Configuration:

Num

Intf#

Direction

MaxLinks

DIALs

1

8

In

2

No

Enter the number of Multilink PPP DIALs interfaces:(0-23) 2

Enter maximum number of active links per Multilink PPP interface: 3

Next, the following prompt will be shown.

For Base Interface #1 (V.34 Base Net) no Dial Circuits are configured! Add a DIALs (Dial-in) Interface for this Base Interface? (Yes, No): [No]y Add a Dial-out DIALs Interface for this Base Interface? (Yes, No): [No] y

Num Intf# Intf Type

BaseIntf#

MP

Direction

Destination

1

3

PPP Dial-in Circuit

1/V34

No

In

N/A

2

4

Dial-out Dials Circuit

1/V34

No

Out

N/A

Save this configuration (Yes, No): [Yes]

Dial circuit configuration saved.

Answering no will take the user out of the DIALs server con®guration.

2.For every valid base WAN interface (V34 or ISDN) in the router, you are asked if you want to add a DIALs dial-in interface for this base net.

vIf the base net is ISDN BRI or ISDN PRI, you are asked if you want to add up to 2 or 23 respectively dial-in interfaces for the ISDN base net.

vIf the base net is V34 then you will also be asked if you want to add a DIALs dial-out circuit for this base net (Dial-out is not supported over ISDN).

3.After answering yes or no to these questions, the current dial-circuit con®guration for that base net is displayed. You can then save the con®guration by answering yes or restart the con®guration for that base net by answering no.

4.After con®guring all of your DIALs interfaces or by answering no to the DIALs interfaces question, you arrive at the DIALs Server con®guration. Here you are asked to enter information about global settings for the DIALs server.

Configure DIALs Server? (Yes, No, Quit): [Yes] yes

Type ©r© any time at this level to restart Dial-in Access to LANs Configuration.

5.Take one of the following actions:

v Enter y to display the DIALs Server prompts

vEnter n to skip DIALs Server con®guration

vEnter q to exit quick con®guration

If you answer yes, the following prompt will be shown. Answering no takes you to the next con®guration section.

Default number of minutes a user is allowed before being disconnected, 0 is unlimited: (0)

6.The default number of minutes on-line determines the maximum connection time for dial-in and dial-out users. Enter 0 if you want to this time to be unlimited. The default is zero if you have not con®gured this information previously.

Appendix A. Quick Con®guration Reference 659

Page 695
Image 695
IBM SC30-3681-08 manual Next, the following prompt will be shown