IBM SC30-3681-08 manual Talk

Using ELS

ELS> nodisplay subsystem all all

ELS> display subsystem tkr all

Ctrl-P

*t 2

As the messages begin to scroll by, look for ELS message tkr.031.

ELS Example 2

SRB bridging is not working.

1.Check the con®guration.

2.Use the GWCON bridging console to verify that the bridging interfaces are enabled.

3.Enter:

*t 6 config> event

ELS config> nodisplay subsystem all all ELS config> display subsystem srb all ELS config> exit

config> Ctrl-P

4.Restart the routing subsystem. When the subsystem has restarted, enter the following:

*t 2

ELS Example 3

Router cannot communicate with an IPX server on an Ethernet.

1.Enter the talk command and the PID for GWCON.

* talk 5

The console displays the GWCON prompt (+). If the prompt does not appear when you ®rst enter GWCON, pressReturn.

2.At the GWCON prompt (+), enter IPX to access the IPX console prompt (IPX>).

3.At the IPX console prompt, enter the slist command to verify that the server is listed. (See the section on monitoring IPX in the Protocol Con®guration and Monitoring Reference for information on the slist command.)

4.Check the IPX con®guration.

5.Enter the following:

*t 5

+ event

ELS> nodisplay subsystem all all ELS> display subsystem IPX all ELS> display subsystem eth all ELS> Ctrl-P

*t 2

As the messages begin to scroll by, look for ELS message eth.001. This indicates that the server has a bad Ethernet type ®eld.

154MRS V3.2 Software User's Guide